Size guide

How to Resize Your Watch

Getting the fit right is easy to do at home. Every metal watch we send out comes with a resizing tool, so you can tailor the band to your wrist in a few minutes — no jeweller needed.

Before you start, find a flat, well-lit surface and a small dish to keep pins and spare links safe.

  • 14–18 cmmost wrists
  • 8 stepseasy to do at home
  • Tool includedwith every metal watch
Get to know your resizing tool

Step 1

Get to know your resizing tool

Your resizing tool works like a tiny vice. The bracelet sits across the channel, and the knob at one end turns a screw with a fine tip that pushes the pin out of the link. Turn the knob anti-clockwise to open the tool, and clockwise to push.

Work out how many links to take out

Step 2

Work out how many links to take out

Put the watch on and close the clasp. Gently pinch the extra bracelet together underneath your wrist until it feels comfortable — snug enough not to slide over your hand, loose enough to slip a finger under. Count the links you've gathered; that's how many need to come out.

Take links evenly from both sides of the clasp so the dial stays centred on your wrist.

Check which way the pin goes

Step 3

Check which way the pin goes

Turn the bracelet over. On the back of the removable links you'll see a small arrow — always push the pin out in the direction it points.

WARNING: Pushing the pin from the wrong end can damage your band.

Set the bracelet in the tool

Step 4

Set the bracelet in the tool

Open the clasp so the bracelet can lie flat. Turn the knob anti-clockwise to open the tool, rest the bracelet in the channel and line the tip up with the pin, so you're pushing the way the arrow points. Turn the knob clockwise, slowly, until the pin starts to slide out of the other side.

Pull the pin out

Step 5

Pull the pin out

Once the pin is partly through, turn the knob anti-clockwise to open the tool, lift the bracelet out and pull the pin free with your fingers. Put it somewhere safe — you'll reuse it to join the bracelet back together. To free a link, take out the pin on each side of it; repeat until all the links you're removing are out.

Line the bracelet back up

Step 6

Line the bracelet back up

With the extra links out, bring the two ends of the bracelet together. The holes should line up perfectly, so you can see straight through them.

Put the pin back in

Step 7

Put the pin back in

Each pin has two ends: a flush end, which is flat, and a split end, which is pointed.

Hold the pin so the split end points the same way as the arrow on the back of the band. Slide it in from the side it came out of, flush end first, and push it in by hand as far as it will go. The split end will be left sticking out slightly.

Press it home

Step 8

Press it home

Place the bracelet back in the tool with the tip lined up against the split end. Turn the knob clockwise until the pin sits flush with the side of the link.

It's normal to feel some resistance near the end — that's the split end being pressed into the link. Give the bracelet a gentle tug to check it's secure.

Tip: keep any spare links and pins in a small bag with your watch box, in case you want to add a link back later.

Not sure about sizing?

If you'd rather not resize it yourself, or you're unsure how many links to take out, email our team at info@onnniii.com. We're happy to help you find the right fit.

Email us